VINYL DECAL APPLICATION INSTRUCTIONS

Clean and remove any contaminants from the surface to which the decal is to be applied. Apply the decal in a 60° to 85° Fahrenheit environment. Do not apply in direct sunlight.

Position decal on surface. On larger graphics, you can add a piece of tape to the top to keep the design aligned during application.

Peel backing from decal SLOWLY. If any of the decal stays on the backing, lay the top transfer tape back down and apply pressure to the transfer tape on the decal and then try again.

Apply decal using firm even strokes from a squeegee (i.e., driver’s license, credit card), working from the center out. Larger graphics should be squeegeed starting from the top, while holding the bottom of the graphic away from the surface, and working the air out.

Remove top transfer tape SLOWLY. If any of the decal remains on the transfer tape, lay it back down on the surface, re-squeegee, and slowly remove it again.